Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
2nd September 2011, 03:02 PM #1New Member
- Join Date
- Sep 2011
- Location
- Kingsley Perth
- Posts
- 1
How to adjust Carbatec 635mm twin drum sander?
Hi
Does anyone know the correct method of adjusting a Carbatec (or H&F or similar) 24"/635mm twin drum sander to achieve correct drum to work table alignment. Mine is out by approx 2mm one end to the other. Does anyone have a handbook perhaps?
Much appreciated
WTIK
-
2nd September 2011 03:02 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
2nd September 2011, 10:58 PM #2
I use a piece of 12mm float glass on the platen to set a constant datum.
I then use a dial gauge in a home made dial gauge base that I use for thicknesser setup. Then it's easy to check for parallel & height differences
You can see the dimensions for the base HERE
-
3rd September 2011, 06:27 PM #3Member
- Join Date
- Feb 2005
- Location
- Tweed Valley
- Age
- 73
- Posts
- 61
Good info MP and I have actually alligned my thicknesser using a similar method to you but I happen to know that WTIK is actually after info on how or where he should adjust the table/drum for that specific type of dual drum sander. Should he be elongating holes to move the bearing retainers (doubt it) or slipping a cog or two on the connecting gear so that one side moves higher or lower wrt the other, or is there a better and much simpler method.
By the way the question only relates to the first drum that remains fixed in day to day use not the rear drum that has a dial adjust at each end to adjust it wrt the front drum.
Much appreciated
BB
Similar Threads
-
Carba-Tec 635mm Wide Drum Sander - Single Drum
By macka75 in forum HAND TOOLS - POWEREDReplies: 6Last Post: 28th October 2021, 10:00 PM -
Hafco 630 twin drum sander
By graino in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 9th June 2011, 09:14 PM -
Carbatec wds-400 drum sander
By justinmcf in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 15Last Post: 3rd March 2011, 11:57 AM -
Carbatec twin drum sander
By jefferson in forum GENERAL & SMALL MACHINERYReplies: 6Last Post: 7th June 2008, 11:54 PM