Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
25th April 2020, 02:48 PM #1New Member
- Join Date
- Sep 2011
- Location
- launceston
- Posts
- 2
Carbatec 6 inch Jointer Problems Advice Required
I have a friends 6 in Carbatec Benchtop planer/jointer and the bearing is nearly gone when i look at the schematic drawings and i see two separate bearings .
Question : Can you just replace the bearings or do you have to buy the whole cutter head .
has anybody done it . i haven't pulled it apart but it looks like you could just replace the sealed bearings
cheers pete
-
25th April 2020 02:48 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
25th April 2020, 08:34 PM #2Member
- Join Date
- Aug 2018
- Location
- Portland Vic
- Age
- 62
- Posts
- 66
I would be guessing that you would be able to replace the beatings,
-
25th April 2020, 09:23 PM #3Senior Member
- Join Date
- Feb 2014
- Location
- Bne
- Posts
- 383
Just replace the bearings, take one into a bearing shop and get a quality replacement. Avoid getting an OEM as these would be inferior to an aftermarket quality replacement
-
26th April 2020, 01:13 PM #4SENIOR MEMBER
- Join Date
- Dec 2012
- Location
- NSW
- Posts
- 133
-
26th April 2020, 08:44 PM #5
Is this the type of Jointer you have?
Jointer_01.JPG
If it is you should be able to remove the bearings quite easily and replace them. You will need to remove the grubscrews No.53 first and then remove the shaft No.33 after removing the retaining ring No.85. It looks like you will have to drive the shaft out with preferably a press, or alternately using a hammer with a brass or copper dolly so you don't flair the end of the shaft. The diagram looks like the cutter head is larger in diameter than the holes where the bearings sit so it can't be taken out in one piece.
The manual this clip was taken from says the bearings are 6201zz and I would expect that all brands are the same but you will be able to check that when you get them out.
Jointer.JPG
Similar Threads
-
Planer/jointer MANUAL required - Carbatec CTJ-196 (6 inch)
By Stewey in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 4Last Post: 18th October 2020, 07:07 PM -
N.S.W. N.S.W. Carbatec 6 inch Jointer
By nicaboo799 in forum WOODWORK - Tools & MachineryReplies: 6Last Post: 16th November 2019, 04:48 AM -
jointer Carbatec 6 inch jointer with CTS Spiral cutter block-Helical Cutting head
By Wigwood in forum WOODWORK - Tools & MachineryReplies: 1Last Post: 22nd April 2017, 11:53 PM -
jointer Carbatec 6 inch jointer with CTS Spiral cutter block-Helical Cutting head
By Wigwood in forum WOODWORK - Tools & MachineryReplies: 0Last Post: 22nd April 2017, 06:51 AM -
Carbatec 8 inch Jointer
By jong in forum PRODUCT REVIEWSReplies: 0Last Post: 1st August 2010, 08:49 PM