Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
Thread: Drill press not running true
-
22nd November 2013, 07:58 PM #1
Drill press not running true
My drill press brought from total tools around 6/7 years ago .
Is not running true .
What should I be looking for when I strip it down ?
Any help much appreciated .
I don't think it is just the chuck.
But I could be wrong .
-
22nd November 2013 07:58 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
22nd November 2013, 08:08 PM #2
Start with the basics.
Check everything is seated well remove chuck and M2 if fitted clean the mores tapper and replace test and see if still running out.
Check bearings slack, while drill is not turned on grab chuck and see if you can physically feel any play.
depending on how hard the bearings have been worked they do wear they may need replacing
some drill press do have adjustment which will help. Check manual if you still have one.
-
22nd November 2013, 08:15 PM #3
And check its not one of the chucks jaws thats crooked or out of whack.
bit of shavings in there can make one jaw sit funny.
-
23rd November 2013, 04:41 PM #4
Thanks for that
Striped it down last night
Cleaned fresh oil and tightened the grub screws up runes a lot better now not perfect
But a lot better
It was a cheap china made drill
-
24th November 2013, 08:39 AM #5
Now you can come service mine glad it is better.
-
6th January 2014, 10:38 PM #6New Member
- Join Date
- Jan 2013
- Location
- Kapunda, South Australia
- Posts
- 4
After 6/7 years of use, you might need to check the quill "slop". On my chinese Toolex drill press, this is an unmentioned screw and locknut arrangement on the side of the head.
Regards - Mark G
Similar Threads
-
wl 46 not running true?
By mimpi in forum WOODTURNING - GENERALReplies: 18Last Post: 23rd July 2011, 11:43 PM -
True running mandrel
By Tiger in forum WOODTURNING - GENERALReplies: 4Last Post: 12th July 2011, 11:29 PM -
drill press not running
By greybeard in forum HAND TOOLS - POWEREDReplies: 8Last Post: 9th September 2009, 07:30 PM -
Chucks running true
By Chumley in forum WOODTURNING - GENERALReplies: 12Last Post: 17th December 2008, 01:19 PM -
bandsaw blade NOT running true...
By Kev Y. in forum BANDSAWSReplies: 7Last Post: 26th January 2002, 09:03 PM