Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Non flat table saw fence
-
23rd June 2023, 12:11 AM #1SENIOR MEMBER
- Join Date
- Mar 2018
- Location
- Sydney
- Posts
- 469
Non flat table saw fence
Hi all,
I decided it's about time that I did a tune up on an old dewalt contractor saw I picked up 2nd hand a few years ago.
While I didn't expect it to be perfect, I've found that the fence has a bow in it, dipping away from the blade by about the thickness of two strips of painters tape at its worst.
The fence is made from boxed aluminium so I can't hammer it out.
Any suggestions on how I can reduce this?
Regards,
Adam
-
23rd June 2023 12:11 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
23rd June 2023, 03:10 AM #2
Add a (melamine/mdf) face to the fence. Shim until it is dead flat. One way to attach is with double-sided tape.
Regards from Perth
DerekVisit www.inthewoodshop.com for tutorials on constructing handtools, handtool reviews, and my trials and tribulations with furniture builds.
-
23rd June 2023, 07:08 AM #3
+1 here but I would avoid the double-sided tape.
I use a variety of disposable or custom faces on my TS fence, & for the fence on the mitre gauge and sleds. I attach them to the fence / sled with t-track bolts and nuts. Simply clamp the face to the fence and drill a pilot hole for alignment through both, then use an appropriately sized forstner bit to drill or create using a router a relief housing to match the head of the t-bolt then drill the clearance hole for the bolt. Check the head of the t-bolt is not proud of the sacrificial face.
Check out router fences for ideas as many use a similar attachment method for the sacrificial face on the router fence/s.
Another option is to replace the existing fence extrusion with something like V-slot 20 x 80mm linear rail (makerstore.com.au)Mobyturns
In An Instant Your Life CanChange Forever
-
23rd June 2023, 09:16 AM #4SENIOR MEMBER
- Join Date
- Mar 2018
- Location
- Sydney
- Posts
- 469
Thanks all.
Perfect timing with the weekend coming up to give that a try.
Regards,
Adam
Similar Threads
-
SOLD: Drill Press Fence (could be a Router Table Fence)
By derekcohen in forum WOODWORK - Tools & MachineryReplies: 5Last Post: 5th August 2020, 01:58 AM -
Looking for "flat top" or "flat grind" joinery table saw blade...
By xxx the next le in forum TABLE SAWS & COMBINATIONSReplies: 5Last Post: 12th June 2020, 02:40 PM -
WEST AUST Incra LS fence/wonder fence, table saw, 2HP dusty, Triton TRA001 router, etc.
By Sore_Dust in forum WOODWORK - Tools & MachineryReplies: 20Last Post: 23rd August 2018, 06:36 AM -
Timbecon Super-Flat Fence
By creativegrain in forum ROUTING FORUMReplies: 5Last Post: 11th October 2015, 09:52 AM -
How flat should my table be?
By matto1 in forum BANDSAWSReplies: 3Last Post: 26th September 2008, 11:46 AM