I recently purchased a unimig viper 185 and I want to weld some 10mm flat bar. I am using gas and the 0.9mm wire that came with the machine. The table inside the side panel only shows settings for up to 8mm.

Can anyone give me the wire feed and voltage to start off with? Thanks!

edit: I watched a couple of videos about finding correct settings and it seems like they are only showing how to find correct voltage which is to start low and weld on some clean stock with increasing voltages until you get the correct sizzle sound. But, none really show how to dial in the correct wire feed


Read the full thread at metalworkforums.com...