Bit of guidance if possible

**DocBug** · 23rd March 2014, 01:06 PM

Hi again,

I just wanted a bit of advice. been teaching myself to tig weld as I tried the part time tafe courses, but my work is too unpredictable and finding it almost impossible to allocate a time.

I have run some beads on 3mm plate, mill scale ground back and just wanted some opinions. I get a bit of inclusion in the weld, using 1 Hz pulse at around 120A max on a foot pedal. Pure argon with a 2.4mm 2% Lanthanated tungsten with a gas Lens.

IMG_2599.jpg

**KBs PensNmore** · 23rd March 2014, 01:28 PM

Hi doc, the welds look fine to me, the inclusions could possibly be that you are taking the nozzle away a bit to far allowing air to get in or that the mild steel has impurities in it.
Kryn

**DocBug** · 23rd March 2014, 09:11 PM

Hi Kryn,

Thanks for that, I found my gas flow was turned down a bit, I just learned , never assume what you set will not be adjusted

All good thanks
Alan

**Karl Robbers** · 23rd March 2014, 11:03 PM

Not specifically related, but worth having in your arsenal.
When welding you will see a little bit of silicon/impurity floating in the puddle. When it starts doing laps around the puddle, you know your power etc is good.
Fiddle around a bit and you will see what I am referring to.
Looking good though.

Thread: Bit of guidance if possible

Thread Tools

Search Thread

Bit of guidance if possible

Similar Threads

Planning ahead and need some guidance...

Air gun + Compressor - Guidance needed

help guidance in purchase.

Starting out and looking for guidance!

Tags for this Thread

Posting Permissions