Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: changing mig wire roll
-
12th June 2020, 12:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
changing mig wire roll
is there a trick to changing the wire roll on a mig that prevents the wire from springing off...took forever to sort it out last time
must write the following on the welder for next time...after putting all coils back onto roll do not I repeat DO NOT push wire end out 3 or times and think all will be good...it only makes things worse lol.
any tricks so that coils dont spring off
was thinking a couple of rubber bands to hold all in place after cutting bent tab off?...install and then cut rubber band?
Read the full thread at metalworkforums.com...
-
12th June 2020 12:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Roll up roll up free vintage handsaws
By Simplicity in forum ANTIQUE AND COLLECTABLE TOOLSReplies: 316Last Post: 9th December 2019, 09:32 AM -
Roll Top Box
By Pauls321 in forum BOX MAKINGReplies: 9Last Post: 9th January 2016, 07:23 AM -
Need Help with Ideas on Hiding Wire in Teak Molding - Wire runs from Instruments
By breezin in forum BOX MAKINGReplies: 1Last Post: 19th August 2012, 05:49 PM -
Roll up, roll up. come see the bearded lady..
By ozwinner in forum WOODWORK - GENERALReplies: 8Last Post: 30th September 2004, 07:52 AM