Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: cheap foot TIG controller
-
22nd December 2010, 08:46 PM #1SENIOR MEMBER
- Join Date
- Feb 2010
- Location
- Ballina, NSW
- Posts
- 725
cheap foot TIG controller
Folks, I've been keeping my eye on ebay for a foot controller for my tokentools tig. Today I noticed they were new at close to half the price from eBay Australia Shop - Arcindustry Welding Equipment: DC TIG Welders, AC DC TIG Welders, Welding Carts so grabbed one . Also noticed that the had Alusync welders new at less than half price too (well half ticket price anyway).... almost makes me want to buy another one !
Usual disclaimer... I don't have any affilliation with this company, do your own research, etc. etc.
- Mick
-
22nd December 2010 08:46 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
30th December 2010, 04:01 PM #2SENIOR MEMBER
- Join Date
- Feb 2010
- Location
- Ballina, NSW
- Posts
- 725
Well.. I had a chance to try out the foot controller yesterday... 1st time ever, so took a bit of getting used to.
One tip I can pass on is to make sure you set your down slope to zero on your welder. At first I was tapering off the current nicely at the end of the weld using the foot controller, then once the arc clicked off, the downslope would kick in and light the weld back up! So I'd get a little pimple at the end of the weld until I figured out what was going on.
Cheers
- Mick
-
17th January 2011, 01:33 PM #3SENIOR MEMBER
- Join Date
- Apr 2008
- Location
- Canberra
- Posts
- 816
Nice one Mick. Im yet to grab a foot control for my token welder but would do it if I was going to be doing heaps of aluminium. Good to know there are compatible units out there for a good price.
Brendan
Similar Threads
-
Speed controller
By rev in forum WOODTURNING - GENERALReplies: 17Last Post: 14th March 2010, 02:52 PM -
Ideas to mod cheap TIG to take foot control?
By SiJ in forum WELDINGReplies: 4Last Post: 15th November 2009, 09:27 PM -
speed controller
By hoopy in forum ROUTING FORUMReplies: 26Last Post: 13th November 2009, 06:26 AM -
Speed Controller
By dj_pnevans in forum WOODTURNING - PEN TURNINGReplies: 12Last Post: 13th November 2008, 08:43 AM -
I want an EVS Motor, 2 or 3 HP with controller.
By Cliff Rogers in forum WOODTURNING - GENERALReplies: 26Last Post: 18th September 2008, 10:09 AM