Hey

I have a cigweld ultra 185 and when doing roughly 4m of weld, in that time the machine shuts off about 4 or 5 times and does a restart and I can't find or anybody to tell me what the problem is. I have taken it in from where i bought it but they can't get it to fault. It most of the times happens when I will stop and then go to start again and it does a quick arc then it will shut down. It has happened a couple of times while in the pool.
Mig welding using .9 wire on auto weld on 2mm. Hope someone has some ideas if its a setting that's been touched.?? Cheers


Read the full thread at metalworkforums.com...