New into the metalworking site.
I need help or advice.
I recently bought a small Disston saw vice.
I wanted to pad the jaws with some thin cork, so I pulled it apart.
Discovered a previously brazed pivoting point had broken again.
See photos.
Now I need it brazed/welded again. Brazing on cast iron or is there new welding products around.
Or looking at the break, any suggestions on a repair.
I'd hate to chuck this out to scrap.
I'm in the Newcastle area.
Thanks in advance.
Lyle
Attached Images




Read the full thread at metalworkforums.com...