Hi All,
I know this is a long shot.
A long while back a acquired a Hirane AS100 (415v single phase) spot welder. I need to make use of it or move it on. I know they were available in a 240v single phase version.
I'm hoping both 415v and 240v use the same transformer. Looking inside I was hoping for some jumpers or links that just needed to be swapped over, but not so.
The primary side of the transformer looks like it has multiple taps, and is connected the the two outermost ones.

Any advice would be a help.

thanks

Dave


Read the full thread at metalworkforums.com...