Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Welding Alloy
-
21st April 2008, 10:26 AM #1
Welding Alloy
While trying to remove the temp sender on SWSBOs 88 Camira I cracked and then snapped in half the thermostat housing.
I'm wondering if it can be welded while still being in the car
I think its cast Aluminum Alloy but not sure (How do I tell).
Yes I can go to the wreckers and get an other one but its a real **** to remove and install.
Has anyone had any success with products like Liquid steel.
How do I weld/glue it (If its possible)Electricity:
One Flash and you're ASH
-
21st April 2008 10:26 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
21st April 2008, 11:31 AM #2
G'day.
I'd say you are schit out of luck trying to repair it on the car.Hooroo.
Regards, Trevor
Grafton
-
21st April 2008, 11:33 AM #3
No good using plastic metal or any similar product. The only possible repair would be welding........BUT ...... I don't think you'll have much luck repairing it in place, so you will have to take it off anyway.
Usually thermostat housings aren't very expensive so I reckon just put a new one on.
Good luck
-
21st April 2008, 11:41 AM #4
Out of curiosity how would you go about welding it.
Electricity:
One Flash and you're ASH
-
21st April 2008, 01:27 PM #5
-
21st April 2008, 07:37 PM #6
Thermostat housings are a consumable part in a car cooling system . I am sure they are designed like this to allow a cheap sacrificial corroding anode part to be easily and cheaply replaced.
Go to your local radiator works.The cost of a new one shall be far less than that of the welding repair.
In addition the corrosion /deposits already embedded into the alloy of the housing would not make for an easy repair, in any case.
Even if it was a housing of some rare and expensive piece of automotive exotica I would fab one from scratch .I would not piddle around with something that is almost guaranteed to give one the schitz in as far as degrees of difficulty of welded repair.
Trust me, its not worth your time and effort.
Grahame
-
22nd April 2008, 05:01 PM #7Too many projects, so little time, even less money!Are you a registered member? Why not? click here to register. It's free and only takes 37 seconds! Doing work around the home? Wander over to our sister site, Renovate Forum, for all your renovation queries.
Similar Threads
-
NB2B alloy
By Brickie in forum METALWORK FORUMReplies: 8Last Post: 1st January 2008, 07:18 AM -
turning alloy
By robyn2839 in forum WOODTURNING - GENERALReplies: 8Last Post: 16th September 2007, 09:20 AM -
Alloy Tote
By Burnsy in forum HAND TOOLS - UNPOWEREDReplies: 0Last Post: 6th June 2007, 11:18 PM -
Brazing Magnesium Alloy?
By martrix in forum METALWORK FORUMReplies: 22Last Post: 24th April 2007, 01:14 PM -
Need suggestions for hole cutting in alloy
By colinshannon in forum METALWORK FORUMReplies: 19Last Post: 12th April 2007, 03:08 AM