Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Welding magnetic clamps
-
23rd February 2020, 02:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Welding magnetic clamps
After some recommendations for welding clamps,
Similar to the link,
I had a couple I brought when I lived in the UK and they were excellent in that the magnets were strong.
But ,the labels have all worn off !!.
I brought a couple a few years back, and there P week to say the least.
But, I should have know better considering were I brought them.
I don’t mind spending some money but ,I don’t want to go over the top either,
They will be used for holding 40/50 mm square tube at ninety degrees.
2 pc Magnetic Welding Holders Soldering Tools, Multi-angle 30°60°45°90° Welding Holder Jig with Center Hole for Soldering, Assembly, Welding, and Pipes Installation https://www.amazon.com.au/dp/B07F7Y6..._EeEuEbK0J7RX6
Cheers Matt.
Read the full thread at metalworkforums.com...
-
23rd February 2020 02:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Parallel Action Clamps Compared to Duratec Lightweight Clamps
By aldav in forum HAND TOOLS - UNPOWEREDReplies: 10Last Post: 6th December 2019, 02:10 AM -
Welding squares (not magnetic)
By MWF FEED in forum WELDINGReplies: 0Last Post: 5th September 2018, 01:11 PM -
Sash clamps versus Bessey K series clamps
By zelk in forum HINTS & TIPSReplies: 8Last Post: 6th September 2007, 10:24 PM