Hi All,

Somebody must know this. What is the wiring layout for a spool gun on to a Unimig Razor 9 pin connector? All the Unimig spool guns are 24v drive on the reel motor. There are plenty of copy spool guns that use a 9 pin connector. When I dig around in there with a mulitimeter the best I can find is 12v on two pins but it seems to have a delay after trigger pull and then stays on after you let go. I cannot find 24v.


Does anyone know how to wire a spool gun to a Unimig Razor?

thanks

Here is an example of a 24v copy wired to Unimig 9 pin

https://www.ebay.com.au/itm/11487502...3ABFBMyKbJw-Bh


Read the full thread at metalworkforums.com...