Thanks: 0
Picture(s) thanks: 0
Results 16 to 17 of 17
Thread: Ezycut Combination machine
-
23rd October 2020, 10:30 AM #16
Hi Daniel and welcome to the forum.
I cant say as I have never seen an Ezycut lathe but you can measure the diameter of the threaded end and count how many threads in 1''. Knowing the size you can get adapters to mount a chuck.
Most woodlathes have a morse taper either morse taper 2 or 1 on some smaller lathes so that is actually good to have. Lets you mount drive centers or drill chucks.
This forum has a turning section with many experienced turners. After you have done 3 posts you can then put up pictures which helps a lot to explain a problem.
Regards
John
-
23rd October 2020 10:30 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
27th November 2023, 11:15 PM #17New Member
- Join Date
- Jun 2014
- Location
- melbourne
- Posts
- 1
copy of ezycut buzzer and saw manuals
table saw and jointer manuals thanks to Cathy
Similar Threads
-
Ezycut combination table saw/planer
By debwp in forum TABLE SAWS & COMBINATIONSReplies: 13Last Post: 3rd October 2023, 10:44 PM -
Old Ezycut Combination
By orraloon in forum TABLE SAWS & COMBINATIONSReplies: 18Last Post: 5th July 2020, 10:03 PM -
Value of Ezycut Combination Saw/Planer/Sander
By flatdog1 in forum TABLE SAWS & COMBINATIONSReplies: 1Last Post: 18th February 2013, 09:44 PM -
Combination machine
By martini in forum TABLE SAWS & COMBINATIONSReplies: 7Last Post: 8th December 2004, 08:22 AM