Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Macson Double Ended Grinder
-
20th September 2013, 03:57 PM #1SENIOR MEMBER
- Join Date
- Nov 2011
- Location
- Newcastle NSW
- Posts
- 775
Macson Double Ended Grinder
Hi all,
I put a posting up recently in the metalwork forum https://www.woodworkforums.com/f65/ma...5/#post1698793 as technically it is a metalwork machine, not a woodwork machine.
I thought I might add a quick post here for three reasons, firstly it feels more like home, and secondly because I think everyone who restores an old machine, is eventually going to have to make their way to the grinder, and thirdly because I expect this grinder was going to be 12", but it turned out to be only 10" (definitely not enough room under the shrouds for a 12" wheel). I didn't realise Macson made a 10" in this style (only found mention of the bigger sizes in the Mcphersons catalogues I have looked at).
20-09-2013 2-33-38 PM.jpg
Note only mentions a 2a or a 3a (12" or 14"), anyone got any documentation of the 10" version?
At first it was a disappointment, but after thinking about it, this is probably a better size for someone like me (big enough to grind anything I am likely to throw at it).
These are some photos (for those too lazy to click on the link above ). I wouldn't say she is the prettiest machine I have ever seen, but I do like the enclosed motor, with the offset base and cast iron shrouds and air vents. The tool rests are not original (I can see the original holes on the shrouds were the tool rest used to go), they look to be shop made, but they do seem well built and even have height adjustment and stops for height (with ways).
macson grinder2.jpgmacson grinder.jpgmacson grinder3.jpgmacson grinder4.jpg
Below is after pulling it apart a bit
photo 1.jpgphoto 3.jpg
So I guess if you are after something a bit bigger than a bench grinder (well probably a lot bigger than a bench grinder), but not as big as some of the industrial ones, then perhaps like me you had not been paying attention to realise that there are smaller versions available. I paid $98 (including fees) for this one, looks like it needs a new bearing, got lucky and have picket up a new old stock $4, but the good news is the wheels are brand new. So fingers crossed for just over $100 and a bit of work, I should have a grinder that will outlive me.
Cheers,
Cameron
-
20th September 2013 03:57 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
Similar Threads
-
Macson Double Ended Grinder
By camoz in forum METALWORK FORUMReplies: 22Last Post: 8th October 2013, 09:29 AM -
Double ended No. 1 Morse Taper
By Alby123 in forum METALWORK FORUMReplies: 8Last Post: 15th September 2012, 01:10 AM -
double ended bar
By david devine in forum SMALL TIMBER MILLINGReplies: 3Last Post: 29th May 2011, 07:48 PM -
double ended pen
By weisyboy in forum WOODTURNING - PEN TURNINGReplies: 3Last Post: 6th December 2007, 07:43 PM -
Double ended coach screws
By echnidna in forum WOODWORK - GENERALReplies: 4Last Post: 26th September 2005, 09:24 PM