Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
22nd April 2008, 09:41 AM #1
Happily receives emails.
- Join Date
- Jul 2005
- Location
- 'Delaide, Australia
- Age
- 65
- Posts
- 8,138
PDRacer bottom undersize problem. Also is the bottom long enough? - no probs and yes
Good section of another thread here
Read from this point
http://www.woodworkforums.ubeaut.com...056#post723056
One person had problems with their ply being not quite long enough (it does need to be a nominal 8ft x 4ft (2440 x 1220) and not the metric size sheet (2400 x 1200) - but small differences are no problem.
Also Mike (a great bloke) found his bottom a bit short - but following the plans would have prevented a small error.
Best wishes
Michael
-
22nd April 2008 09:41 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
Reply With QuoteSimilar Threads
-
Finishing the bottom of goblets
By benji79 in forum WOODTURNING - GENERALReplies: 10Last Post: 11th June 2007, 12:13 PM -
Turning the bottom of the bowl? Help please
By chitswood in forum WOODTURNING - GENERALReplies: 43Last Post: 9th June 2007, 03:24 PM -
Bottom of the barrel
By himzol in forum WOODWORK - GENERALReplies: 2Last Post: 25th May 2004, 10:03 AM -
bottom of bowls
By 0zwood2003 in forum WOODTURNING - GENERALReplies: 8Last Post: 20th May 2004, 11:25 PM -
scraping the bottom of the barrel
By Gino in forum WOODIES JOKESReplies: 0Last Post: 25th December 2001, 12:25 PM
