Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 20 of 20
Thread: Puddle Duck in the UK
-
1st November 2008, 04:20 AM #16
I've found some hardwood!!! But it isn't long enough!!
Is it best to butt join all the bits together like it says in the instructions, or, to make the centre board and rudder separately?
Its also all a heavy hardwood (I'm not sure which, I'm new to this!). Will this be OK if I alternate with a knot free softwood?
Thanks all. Hooked already. Asking and scrounging from everyone I know!!
-
1st November 2008 04:20 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
1st November 2008, 09:03 AM #17
Howdy ... sorry,
Missed the reference to hardwood.I f you are wanting to use it for the appearance then make the hardwood strips a bit narrower (or a lot narrower - depending on the appearance you are happy with) so the boards don't end up too heavy.
Great that you are making progress!!!!
Best wishes
Michael
-
2nd November 2008, 12:58 AM #18
Almost there!! Thanks for your help.
Is it alright to make the centre board and rudder separately? or should I butt/scarf join pieces together to make the correct length?
Thanks
-
2nd November 2008, 07:09 AM #19
If you've got enough wood for each (i.e. pieces are long enough with some waste which you can cut off later), then there is no point joining them all together just to saw it in half later. Pete and I did our rudders and centreboards separately. It also means your clamps can be closer together, unless you have an excessive amount of clamps!
Cheers,
Mark
-
2nd November 2008, 08:41 AM #20
Howdy,
No problems either way from the designer's point of view.
We made them together because the Biting Midge had an excessive number of clamps ... also because when I have done multiple foils in the past I usually make them in one piece because it makes it easier to get them accurately shaped.
Or at least ... I think it makes them easier.
OK, OK ... it is a psychological reason!!! No one has that many clamps!!! Make them separately if you want.
If you are short of clamps you can fill some of the void with brown packaging tape. Also I have sometimes made up temp bar clamps with pieces of wood or a piece of chipboard that acts like a bed for the foil blank. Use the screws to put a block either side of the blank on the bad. Then tap some wooden wedges in either side.
Of course like all more complex gluing jobs ... make sure the whole system works dry! And then do it with the glue the second time when you know it all works.
Michael.
MIK )
Similar Threads
-
Big Puddle
By wheelinround in forum COMPUTERSReplies: 0Last Post: 16th August 2007, 06:38 PM -
Puddle Duck world championships
By Daddles in forum Michael Storer Wooden Boat PlansReplies: 56Last Post: 9th November 2006, 09:23 AM -
Duck!!
By John Saxton in forum WOODIES JOKESReplies: 0Last Post: 6th November 2006, 08:52 PM -
An exercise in the beauty of constructing a racing puddle duck
By Christopha in forum BOAT DESIGNS / PLANSReplies: 30Last Post: 14th February 2006, 07:05 PM