Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: C11G , Geckos ,Mach3 problem
-
14th December 2009, 03:38 PM #1Novice
- Join Date
- Sep 2008
- Location
- australia
- Posts
- 23
C11G , Geckos ,Mach3 problem
I am attempting to install a C11G Bob to run 2 Gecko 320 and 1 Gecko 201
The 201 runs the Z Stepper.
The Stepper will only run in one direction . Anyone explain what the problem may be.
I use Mach3.
WJF
-
14th December 2009 03:38 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
14th December 2009, 03:52 PM #2SENIOR MEMBER
- Join Date
- May 2005
- Location
- Cockatoo Vic
- Posts
- 996
Sounds like for some reason the direction signal is not getting to the drive.
Maybe it is not being sent from Mach because of a wrong pin setting. Verify that first.
Then check with a meter at the drive that the direction signal is getting there and is changing state with direction change.. Will be a 5v signal.
Chase it down logically and you should get a good sense of where it is getting lost.
Greg
Similar Threads
-
Mach3 license
By chrisb691 in forum CNC MachinesReplies: 5Last Post: 21st October 2008, 07:12 PM -
Mach3 setup
By chrisb691 in forum CNC MachinesReplies: 5Last Post: 21st October 2008, 01:39 PM -
any one had this problem before
By George G in forum WOODTURNING - GENERALReplies: 7Last Post: 19th May 2007, 01:55 PM -
Is there a problem
By Arron in forum WOODWORK PICSReplies: 1Last Post: 28th January 2006, 03:53 PM