have to laugh , i just received my , 6545 from hong kong , aluminium angles were bent , spindle cable dosnt fit , no Australian plug ,at least mine came with a water pump cable , tried emailing them , no answer :2tsup:, they held up the post untill the 6 week complaint ( paypal ) was over
powered it up , no hold torque on the steppers , instructions say , contact them , i did , no return email ( grab the money and run )
ill add a photo of the water pump cable ,
put a mutly meter on the wires and found that
1 is red 2 is blue , on the back of the controller plug with notch on top,1 red is left , 2 blue is right (looking from out side )
the Spindle cable , comes off at the spindle , so i was going to wire it up 1-1 2-2 3-3 4-4 , using a multi meter to match there wires , but the numbering on the plugs is different , clock wise from notch on spindle end is 1342 ,the original plug on the cord has 1 at the notch 342 set up ( they are wired 1-1 2-2 3-3 , with no connection on 4 , no earth ??/ ) , and the spare plug they supply ( clock wise from notch ) is 1234
!!!!! danger no earth on machine !!!!!!!
and no limit switches
the stepper motor wires are not shielded , properly why the spindle cable is not with them in cable chains ,