Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Dual Probe/Touch-plate set-up
-
11th December 2013, 05:08 PM #1
Dual Probe/Touch-plate set-up
Hi Guys - very long time with no post, but I am back with a question for your consideration - and wisdom - I have already sent a PM to Rod, but thought it a bit tough loading him up with the issue on his own - so over to the open forum.
I want to run a Digitizing Probe on my machine, and I have 'found' that Mach3 now has a Digitizing Wizard included, and I can use that for the probing.
However, I have one small problem. I am using Greolt's Touch Probe macro and running my touch plate from input 13 on a CNC4PC C10 break-out board (been running well for several years now - many thanks Greolt).
I actually have two C10 break-out boards on the machine, and have a couple of spare inputs available, but Mach3 has only one 'Probe' setting under inputs.
Can't work out how to have both the Touch Plate and a Digitizing Probe working concurrently - needs someone with a lot more electronic knowledge than i have, I reckon.
Just wondering if you know of any work-around so I can keep my Touch Probe and also run the Digitizing Probe?
Tough call I know.
Cheers
Noel
-
11th December 2013 05:08 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
15th December 2013, 05:17 AM #2Member
- Join Date
- Jul 2009
- Location
- Detroit, Michigan
- Age
- 60
- Posts
- 72
Last week someone on the Mach3 forum came up with this idea. Assign the Probe to input #1 (or any input) and write a Brain to trigger the Probe input whenever Input #1 is active. There's probably a very slight delay (milliseconds or less?) but probably not noticeable at slow probing speeds.
I haven't actually tried it, but I posted the Brain here:
BrainGerry
Similar Threads
-
Do Not Touch!
By Rodgera in forum WOODIES JOKESReplies: 0Last Post: 17th June 2011, 12:08 PM -
digitizer touch probe on serial port? is it possible?
By commadore129 in forum CNC MachinesReplies: 0Last Post: 12th January 2010, 07:00 PM -
Touch Probe for Digitizing
By jb2060 in forum CNC MachinesReplies: 13Last Post: 13th October 2008, 11:04 PM -
In Touch
By fred.n in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 3Last Post: 11th June 2006, 05:19 PM