Thread: working with net downloade *.dxf files used aspire to help clean up

I downloaded an aztec calendar from the net , a *.dxf file about 8000k,wheni loaded it into aspire 4.0 it took forever as it turned out to ne 146 x146 in
I then shrunk it down to 16in x 16 in and it took awhile again but finally did come through.This was a complex diagram .There were open vectors etc,i cleaned it up ran it through corel to reduce the nodes placed it back into aspire sized it and exported it as a*.dxf for the laser
and at this time i save it as an aspire file ,which took very long and twice i had to stop it .
It created between 100k or 150k file ,is there a limit does anyone know .Maybe i was getting close
i finally got results but it took awhile


lasering an aztec calendar on birch plywood - YouTube lasering an aztec calendar

i use aspire 4.0 for both my machines and i am always learning