Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 31 to 36 of 36
Thread: On order
-
21st October 2012, 11:17 PM #31
DSC_0291.jpgDSC_0294.jpgHave been doing bits of the build as much as I can. Ran the spindle up and all good, I do have a question about the wiring from the VFD to the controller. On Homann wiring diagram it say to connect from pin 9 to VFD VR(+10) but I don't have a VR(+10) but I do have a 10V and next to that on the board is three pins and a jumper VI/VR. I take it that I have to use the jumper to make the VR.
Thanks Davidgiveitagoturning @hotmail.com
-
21st October 2012 11:17 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
22nd October 2012, 01:11 AM #32
I have just hooked up my spindle to mach 3 and I connected pin 9 to 10v, pin 8 to VI, pin 7 to ACM. I didn't touch the jumper at all. I have put a switch in between FOR and DCM until I get a relay.
I also had to adjust the motor outputs for the spindle in ports and pins. I set Step Port and Dir Port to 1 and then everything started to work. (I had also loaded the xml file from Gecko http://www.geckodrive.com/g540-xml-file so the adjustments were done to their file)
Regards
Warrick
-
22nd October 2012, 09:12 PM #33
Thanks for that Warrick will do it this weekend.
Davidgiveitagoturning @hotmail.com
-
22nd October 2012, 10:20 PM #34
-
23rd October 2012, 09:24 PM #35
Ok thanks for that.
Davidgiveitagoturning @hotmail.com
-
28th October 2012, 04:22 PM #36
Well I have done most of the wiring as per PDF. When I power up I get the green power light but as the computer starts I get the fault light and the power light. I take it there is an issue with the computer. I have changed it to EPP mode and had a look at the set up in Mach3 but still no luck. Any hints?
Thanks David
giveitagoturning @hotmail.com
Similar Threads
-
For those that order from the US
By Reece in forum WOODTURNING - PEN TURNINGReplies: 17Last Post: 14th September 2010, 09:15 AM -
Forum Pen Kit Order
By funkychicken in forum WOODTURNING - PEN TURNINGReplies: 21Last Post: 22nd September 2008, 08:26 PM -
Did I order this?
By Gra in forum WOODIES JOKESReplies: 1Last Post: 8th August 2007, 01:10 AM -
My first Order
By Mrs Woodpecker in forum WOODTURNING - PEN TURNINGReplies: 9Last Post: 26th July 2007, 02:44 PM