Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: VFD Help needed
-
11th January 2010, 03:02 PM #1New Member
- Join Date
- Feb 2007
- Location
- Seven Hills
- Posts
- 7
VFD Help needed
Hey Guys,
Need help, having trouble with a keling VFD. Basically i can not enter any content, into the PD codes.
Firstly I didn't get a manual with the unit so that didn't start well. From the info that i have found it may be a Huanyang and the only model number it has is a KL1500. I've searched the thread's on this forum and on CNCzone, i still haven't got any further with the VFD. From what iv'e read and seen on youtube, i should not be having this sort of trouble. Uploaded some image for reference.
First image is the VFD in question.
Second image is at power up with that display flashing, hope someone could tell me what it means
Third image is from when I press the "prog" button, pressing any other button does nothing. Once i get to PD000 i can use the up or down arrow keys. the whole display is still flashing.
The only other button that help's is bottom-left hand corner button, which moves the digit's e'g PD001,PD010,PD100
That's is all i can do. again i can not enter any content. Any advice to enlighten me would be much appreciated. And to think this is my last phase in my CNC build, and is giving me the most headache.
-
11th January 2010 03:02 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
11th January 2010, 04:04 PM #2
Woodtickler,
Your unit looks exactly like mine which is the Huanyang unit.
I think your correct with the 3rd image which shows the setup menu. From there you may need to hit the "set" button and use the up and down buttons to increase or decrease the values.
If this fails yell back and i can check my unit tonight for the exact sequence required
/M
-
11th January 2010, 04:38 PM #3New Member
- Join Date
- Feb 2007
- Location
- Seven Hills
- Posts
- 7
Mike,
Wow thanks for the quick reply. will that's good new's that you have the same vfd. As mention earlier i can enter any PD code e.g PD012, but i can not get to the point of seeing the setting or even to change the setting's, I've actually go a printout of one of your replys in 'Tips for newbie Huanyang VFD users' in which you state the PD codes to change first,
Because i'm flyling blind here, i assume when you, once you have your selected PD code, you push some button, to view current, value, then selet another button to edit it. At the moment only arrow keys, prog key and buttom left corner key, what ever that is working for me. I'm just hope I don't have a faulty Unite.
Ray
Similar Threads
-
Some help needed
By Harrison in forum HAND TOOLS - POWEREDReplies: 10Last Post: 16th October 2009, 04:53 PM -
help needed plz - info needed on turning tools
By theyoungster in forum WOODTURNING - GENERALReplies: 5Last Post: 7th August 2007, 02:31 PM -
red gum needed
By johnsymons in forum TIMBERReplies: 1Last Post: 21st April 2005, 08:16 AM -
Help needed
By fordo in forum HAND TOOLS - POWEREDReplies: 4Last Post: 24th December 2003, 08:54 AM