Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Stanley Multi Angle Vice
-
15th February 2020, 10:56 PM #1
Stanley Multi Angle Vice
Bought this last week and have given it a bit of a workout. I use it to hold parts while I'm soldering and so far it has been great.
Vice 1.jpgVice 2.jpgVice 3.jpg
I nearly bought the cheaper Chinese version but couldn't wait for 4 weeks (or longer ) for it to arrive.
Bought it off eBay for $50 delivered (Chinese version was about half that). It was sent overnight, which was a bit of a welcome surprise.
It's all metal construction and really good quality. The vice jaws are removable, hardened steel. 75 mm wide and open to 70 mm. It comes with 2 slip on soft jaws that fit snugly over the steel jaws.
The clamp that holds it onto the table is substantial and can fit on to a 60 mm thick bench top. The ball and socket joint locks down solidly and is also quite substantial.
I'm really impressed with this and glad I didn't go for the cheaper version. Highly recommended. If you have a use for one of these I don't think you will be disappointed with the quality of this one.
The higher end version of this is the Panavise and while these are very good, a basic unit will cost you well over $100.Those were the droids I was looking for.
https://autoblastgates.com.au
-
15th February 2020 10:56 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
15th February 2020, 11:17 PM #2.
- Join Date
- Feb 2006
- Location
- Perth
- Posts
- 27,839
I bought one for SWMBO to take "camping and carving" and as expected she's used a few times and now its cluttering up the shed.
Seeing yours surrounded by electronics gear got me thinking I might use it in my E-workshop although it might still be too high for me it that situation as I like to work sitting down.
I originally designed it to go under a vehicle tow ball like this but it rattled around too much
The vertical position can be changed by sliding it up and down that HD Unistrut channel
Vicestand.jpg
So this is what I came up with - not my idea someone elses from WW or MW forums
It was OK
IMG_3507.jpg
On my e-bench I have this gizmo.
The "ball and socket" are from a 1972 Datsun 180B side mirror.
It's also too high even when fully laid over on its side.
IMG_2337.jpg
-
16th February 2020, 12:12 AM #3China
- Join Date
- Dec 2005
- Location
- South Australia
- Posts
- 4,479
Glad you are happy with it Stanley these days is just another word for rubbish, maybe they have picked their game
Similar Threads
-
Stanley Vice Colour?
By smidsy in forum THE WORK BENCHReplies: 1Last Post: 16th June 2018, 02:47 PM -
Multi purpose vice
By kippara in forum GENERAL & SMALL MACHINERYReplies: 2Last Post: 8th February 2017, 08:38 PM -
Stanley high angle smoother
By mic-d in forum HAND TOOLS - UNPOWEREDReplies: 0Last Post: 6th October 2010, 10:46 PM -
low angle 4-1/2 Stanley WIP
By Ironwood in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 48Last Post: 11th September 2008, 07:20 PM