Thread: The Blue Table

Pine?

The top is very cupped, so I might use the saw kerf method (cut underneath) to flatten it.

Hi,

don't forget to try the wet lawn in the sun trick before you go kerf cutting!

Good luck

David

Originally Posted by goodwoody

Pine?

I originally thought it was Victorian Ash (Tassy Oak) because of the way the end grain looked.
I'm thinking now, after stripping it, that it may be Blackwood.

Originally Posted by Xanthorrhoeas

Hi,

don't forget to try the wet lawn in the sun trick before you go kerf cutting!

Good luck

David

I've already tried that . I left it on the wet lawn in the sun and clamped it to dry with some cauls afterwards.
Two days after removing the dry top from the clamps, it went back to where it was before

4.jpg

It's not too bad, but I do want to bring it down a bit more.

The parts are all stripped and washed.
The old dowel holes were drilled out, and the table glued up.

1.jpg2.jpg3.jpg

I'll work on the cupping in the top next.
A couple of fine saw kerfs underneath should do the trick.

Looking good, and apart from the top, a pretty straightforward resto on this one I would think Stu, for a guy with your skills.

Going on the pics, I too would plum for blackwood. The grain and colour seem right for that.

Looking good.
What did you use to strip the paint?

Originally Posted by Horsecroft88

Looking good, and apart from the top, a pretty straightforward resto on this one I would think Stu, for a guy with your skills.

Going on the pics, I too would plum for blackwood. The grain and colour seem right for that.

Should that be 'plump'?

Originally Posted by hiroller

Looking good.
What did you use to strip the paint?

I prefer mechanical stripping if possible.
I used a shavehook and a card scraper.

After this I used paint stripper to soften the paint within the grain, and then gave it a good scrub with steel wool and metho.

I only needed to make a couple of saw cuts underneath the top.
The top will be nailed on, but I decided to put a couple of screws through the aprons into the top to pull it down as much as possible.

1.jpg2.jpg3.jpg

A couple of coats of shellac.

5.jpg6.jpg

The top's sitting nicely now.

4.jpg

The nail holes have been plugged with coloured wax.
It's had a light polish and a buffing with wax.

7.jpg

The table has been moved inside.
I've got it sitting next to my lounge chair. Perfect for my nightly glass of Shiraz

That is nice to see Stu, but mate, where is the glass of red ?? It seems to be missing in action. Well done, I am sure your wife must be most impressed with the table's rejuvenation. Cheers Dave

Interesting what you can find under a few layers of paint

nice job but it looks like someone pinched your glass of Grange

Looks much better.

i often wonder if the home improvement would want to strip back to a more natural finish.

Originally Posted by Sawdust Maker

nice job but it looks like someone pinched your glass of Grange

If I could afford Grange, I would protect it with my life

Originally Posted by Christos

Looks much better.
i often wonder if the home improvement would want to strip back to a more natural finish.

I hate shabby chic with a passion