Thread: Restoration of mahogany dining table leg

that is a top job

WOW! Six thumbs up! Thanks.

Woodwould, please do not refer to yourself as an AVERAGE wooderworkers It makes the rest of feel inept

Woodwould -

If I may ask, how did you clamp the grafted wood onto the table leg?

I have a similar problem with a table leg that has broken, and I believe I can glue it back together, but am not sure how to hold the joint together.

Thank you for the excellent example!

Re-gluing the broken tip of a saber leg is actually more difficult than gluing on an entirely new piece as illustrated above.

Obviously the two pieces need to be clamped perpendicular to the joint. This is tricky with a sabre leg as you have discovered. There are several ways to tackle the problem though.

If the fibres in the joint are tight, then some glue may be all that's required in conjunction with strategically placed masking tape to pull the joint together.

If the joint wont sit nicely without pressure being applied, then clamping will be necessary.

The all-clamps method: If you have plenty of clamps, position one horizontally on the underside of the main leg and one horizontally above the broken toe. You should then be able to clamp the joint firmly with additional clamps bearing on the ones attached directly to the wood.

The block method: If you can't obtain sufficient pressure with clamps alone, then some wooden blocks attached to the leg parts will offer better purchase for the clamps.

You will need to shape two blocks to the profile of the leg parts (in place of the clamps as described above) and ensure the clamping surfaces are parallel with the break/joint. To attach the blocks to the leg, you can either glue them on temporarily. Hot melt glue is one possibility assuming the finish on the leg will withstand the removal of the glue afterwards (not so important if you'll be refinishing the whole piece). If the finish has already been removed then horse sauce (animal glue) has worked for me for a few decades.

Which ever method you adopt, be sure to clamp a couple of waxed (to prevent the glue from sticking) flat blocks either side of the leg (assuming a similar 'square' profile as the example in the pictures above) to perfectly align the broken piece.

Good luck with it all and post some pictures of the results please so we can see how you managed.

Fascinating. What sort of stains and what process to you go through to match the colours?
Jim

I honestly don't remember that exact job Jim, but it would most likely have involved a natural water-based stain, possibly some shellac and waxes.