:2tsup: x 100
Printable View
:2tsup: x 100
Yet again, no words available to describe your work Keith, a wonderful thing to see, appreciate the love and devotion which went into it. One day, I am going to request to visit this, and the other works of art. :)
Regards,
Gus
Really looks amazing Keith a great loco makes mine look a little plain
No way Derek - Yours looks great. A very skillful build. Kids can't play with my loco whereas they can with yours.
A top build by you.
Regards
Keith
Hi All,
Back onto the Thatcher Perkins. Making the base for the locomotive with the sleepers, rail clamps and rails. Making the base in 2 sections (otherwise too heavy) as it is over 2 metres long
The sleepers are made of pine and weathered using a wire brush on my angle grinder, digging out along the grain for the weathered affect.
There are 20 sleepers in total. They will be painted in a brown wash to highlight the weathering.
Attachment 482248
The rail clamps are cut out using various cuts on the table saw. There will be 4 clamps per sleeper. I have painted them in "Domino" and weathered them to look like they are rusted by using a wash of red oxide and dried using a hot air gun.
Attachment 482249 Attachment 482250
The toy making has been fun and enjoyable - but I love working on locomotives and their equipment.
Regards
Keith
You never cease to amaze me with your creative attention to detail !!!!!!
I've been wanting to try making some weathered wood it really added that little bit of extra detail.
Got to love it!!!:2tsup:
Thank you for sharing this.
One word, three letters: Wow.
Hi All,
Nearly finished this locomotive now.
Assembled the track. The track was cut into the rail section (I) using the table saw with multiple runs and then sanding the cuts. I then painted in "Domino" and as per the rail clamps weathered with red oxide wash to simulate rusting. The top of the rail is painted in spray paint (Pewter) to simulate the rail wear on the top of the track.
The ballast is small pebbles purchased from Bunnings plant department. They are available in small bags and are used to decorate the top of pot plants. I laid and secured the sleepers in position and then spread out the pebbles pretty thinly. I painted the base of the tracks in Mission Brown so if there is any base showing through it is camouflaged. I used a mix of 50% PVA glue and 50% water sprayed on in a fine mist to soak all the pebbles. I used one litre of the mix to secure all the pebbles and left for 48 hours to dry.
The rail clamp pins are cut down spiral head nails. They are glued in with 5 minute aradite.
Attachment 482457 Attachment 482458
Regards
Keith
That second photo looks the real deal Keith, well done’
Cheers Peter
Great work!!!
I can remember walking many a mile of tracks like these in my youth.
Thanks for sharing all this with us.:2tsup:
Nice track Keith. Just need a few weeds here and there perhaps? :D
I guess this project is just about finished. At least with all the restrictions our wonderful politicians have given us, we can still work in our sheds/workshops providing we have or can get supplies. Well done on getting near the terminus on this one.
Hi All,
Thatcher - Perkins is all done. It's been an enjoyable build. A few challenges especially the 2 step diameter changes in the boiler assembly.
Cathie wanted to take a photo of me with the loco - so have included that as well.
The final photo shows in the back room display area with a couple of my other locos - Stephenson's Rocket and the Stirling Single.
Thanks to everyone who has supported and viewed my loco. Much appreciated :2tsup:
Attachment 482586 Attachment 482587 Attachment 482588 Attachment 482589
Regards
Keith