Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
Thread: Introduction
-
28th February 2022, 02:42 PM #1New Member
- Join Date
- Feb 2022
- Location
- Andamooka SA
- Age
- 69
- Posts
- 1
Introduction
First time on a forum for me. Carpenter & Joiner by trade and nearly ready to retire. Never done much woodturning, but recently bought an early model Woodfast lathe which has no indexing pin. Has any one information on the correct one and where I can purchase it? Info stamped on lathe bed near headstock is L 1667 70.
-
28th February 2022 02:42 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
28th February 2022, 04:57 PM #2
G'Day & Welcome to a top forum......
There are quite a good few members around Adelaide and throughout SA plus the rest of the country.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork......
Cheers crowie
PS - May I suggest that you start a new thread in the general or woodturning or machinery/tool sections asking about the lathe advice.
You'll get a lot more views and thus potential answers, cheers.
-
28th February 2022, 10:04 PM #3
Welcome to the forum.
-
1st March 2022, 09:56 PM #4SENIOR MEMBER
- Join Date
- Jul 2004
- Location
- Adelaide
- Age
- 76
- Posts
- 768
Welcome to the forum.
Regards
Keith
-
9th March 2022, 02:38 PM #5GOLD MEMBER
- Join Date
- May 2013
- Location
- Rockhampton QLD
- Age
- 68
- Posts
- 2,346
Welcome to the forum.
-
10th March 2022, 07:14 AM #6
Welcome to the forum.
Similar Threads
-
An introduction
By Michael G in forum G'day mate - THE WELCOME WAGON -Introduce yourselfReplies: 3Last Post: 15th October 2011, 06:11 PM -
Introduction.
By kkwall in forum WOODWORK - GENERALReplies: 15Last Post: 5th January 2008, 09:38 PM -
Introduction
By Wood Worm in forum WOODWORK - GENERALReplies: 9Last Post: 10th December 2007, 07:53 PM -
introduction
By woolclasser in forum WOODTURNING - GENERALReplies: 13Last Post: 2nd September 2007, 08:04 PM