Thread: nail free decks - opinion

Suggest you visit our sister site Renovate Forums - Powered by vBulletin and post in the DECKING - Renovate Forums forum

There's a no nail decking place near me. They charge about 7.50 per lm for the boards (90x25) with fittings (ie plastic thingos and screws). You need to buy glue on top of that but it's not that expensive. Obviously, sub floor is not included in that price. (nor labour, of course). Also, note that is Melbourne, but cost should be similar. It's mainly aimed at the DIY market.
TM

Can't help with your question but welcome to the forum.

I also welocome you to the forum. I am on the other one as well.

Hi All
I have a new decking made from merbau and will be coating it soon with spa'n' deck, some of the fixing nails are just above surface and I intend to sand down deck...must they be flush?

The nails should be sunk below the surface of the deck if you are sanding - otherwise you'll sand any galvanising off them if they are not stainless steel. Worst case scenario is that you could end up effectively sanding the heads off if they are too proud of the deck!

G'day LW and welome to the cubby.

Think Wongo did a deck recently, just can't remember if it was no nails.

If the system was really good I would prefer it to nailing because you won't have to punch protruding heads, you won't get nails working loose and then protruding above the surface as the deck ages. These can be murder on tender feet.

i build about 4 or 5 decks a month, i always scratch my head when asked this question as i can only think about potential cupping or twisting of the boards over the long term