Thread: Blast gate with 100% efficiency

.

Originally Posted by Wongo

Any comments?

You really don't want me to finish EVER do you???



Another great idea from the world's oldest engineering culture methinks!

The only bit I don't get, is the hinge/lock arrangement..... how and why? I would have thought that just replacing the gates with MDF would have been close to "very" efficient, without having to clamp the gates shut?

Are you using a 1200 DC?

Cheers,

P

Midge,

Good question. It is the same thing I have been thinking for a few days.

Remember this: sliding motion = gaps

There is nothing you can do about it. I want something very good, not very close. Yes you need 2 extra steps to close and open the gate but they are 2 very little steps.

I am still thinking though.

Originally Posted by bitingmidge

The only bit I don't get, is the hinge/lock arrangement..... how and why?

This is the only way to sandwich 2 foam sheets and a MDF gate in the middle.

what about covering the bit in the middle with some rubber ?

and what happens when your clamp slips due to vibration or bumping it ?

great idea though... if you only have a couple of machines it wouldn't be a big inconvenience...

worth a greenie

Originally Posted by Zed

what about covering the bit in the middle with some rubber ?

and what happens when your clamp slips due to vibration or bumping it ?

great idea though... if you only have a couple of machines it wouldn't be a big inconvenience...

worth a greenie

Zed,

Thanks for you feedback mate. I use spring clamp for a good reason. It is very strong and quick to release. It is impossible to slip.

Also, you only need to close one gate and open one gate each time. So it isn’t a big inconvenience.


Anyway, I think I will go ahead and build it this way.

it wasnt a critisism it was a question - rubber is one of the best sealers around however your idea is pertty good I think, you've done well.

Just one criticism Wongo, you didnt paint them JET white.

What were you thinking?

Good idea.

Originally Posted by Wongo

Midge,


Remember this: sliding motion = gaps

Not with my drawers

(I wish)

On second thoughts, perhaps I should have let this one go through to the keeper

Originally Posted by Wongo

Remember this: sliding motion = gaps

Interesting design Wongo. You are right about those commercially available gates, they are very ineffecient.

I used a sliding home made version based on a sliding panel (see my web site) which is based on a design by Phil Bumbalough. I find there are no gaps as the suction from the DC forces the sliding panel against the sides and seals it.

My only comment on your design would be that you have to line up the hole in your panel with the duct by eye each time. Or is there a guide locating pin I cannot see?

Cheers