Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Axle steel - what grade?
-
27th June 2012, 06:28 PM #1
Axle steel - what grade?
I've been "blessed" with a few old 1.5" trailer axles from about 40-50 years ago as a result of cleaning out a friends shed. It seems too good a supply of stock to waste but I have no idea what grade of steel they are likely to be. Any ideas what its likely to be given its age?
-
27th June 2012 06:28 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
27th June 2012, 08:29 PM #2SENIOR MEMBER
- Join Date
- Jun 2004
- Location
- Kyabram. Vic
- Posts
- 826
Gavin,
If they are anything like XF Falcon they are tough. Finish well enough and not stringy. I think modern day axles are 8650 or thereabouts.
I made a shaft for a shaper from the Ford one. It runs in bronze bushes and with plenty of lube the bearing surfaces are unmarked
Ken
-
30th June 2012, 01:16 AM #3GOLD MEMBER
- Join Date
- May 2011
- Location
- Murray Bridge SA
- Posts
- 3,339
About 40years ago I worked for a company that made trailers and their own axles which I believe was made from Duraflex (a type of spring steel).
Kryn
-
9th August 2012, 10:46 PM #4Intermediate Member
- Join Date
- Mar 2012
- Location
- adelaide
- Posts
- 27
ditto to the "Duraflex"
-
14th August 2012, 03:45 AM #5GOLD MEMBER
- Join Date
- Oct 2003
- Location
- Sydney,Australia
- Posts
- 3,157
Again, depending on age, a lot of half axles were/are induction hardened on the surface, about 3mm or so deep. I was shown some etched samples in the 1970's and the difference in grain structure was remarkable.
Similar Threads
-
stainless steel grade for hardening
By thorens in forum METALWORK FORUMReplies: 6Last Post: 6th April 2012, 11:23 AM -
loose axle
By burraboy in forum TRAILERS & OTHER FABRICATED STUFFReplies: 4Last Post: 26th November 2011, 06:09 AM -
machining 1045 grade steel
By welder in forum METALWORK FORUMReplies: 2Last Post: 13th August 2010, 07:16 PM