Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
15th June 2019, 12:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Brake controller induced voltage in wire
Have an interesting issue on a truck I am wiring up for a trailer.
The truck is 24V. The controller is a 24V-12V controller of a cheaper variety as the truck is of off highway use only.
I also have fitted a 24-12V converter to go to the reverse light pin to act as an auxillary 12V supply to charge the breakaway battery and also charge a battery on the trailer that powers the hydraulic tipper.
Both wires are 6mm in the same sheath and run from the cab to the rear of the truck (about 4m). Upon testing it magic smoke was released from the 24-12V converter. A power diode burnt up. Replaced it and all is fine.
Isolating and testing the wire that goes from converter to rear finds that when the brake is applied a voltage is induced into the converter wire.
What I believe is happening is the electric brake controller puts out a pulse of electricity as it is a pulse width modulator. This was confirmed by a handheld oscilloscope. This then induces the same voltage in the parallel wire which is the converter wire which the oscilloscope confirms. The voltage according to the oscilloscope is 17V peak. Which would explain why the converter diode burnt up.
So I need to run a second wire on the opposite side of the truck to make sure the brake controller does not create problems.
Read and reply to the full thread at metalworkorums.com....
-
15th June 2019 12:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Coloured Heartwoods & wood stains - Fugally-induced
By Euge in forum TIMBERReplies: 6Last Post: 25th May 2015, 01:14 PM -
Brake controller for tandem trailer
By chambezio in forum TRAILERS & OTHER FABRICATED STUFFReplies: 5Last Post: 11th January 2013, 11:05 AM -
Need Help with Ideas on Hiding Wire in Teak Molding - Wire runs from Instruments
By breezin in forum BOX MAKINGReplies: 1Last Post: 19th August 2012, 05:49 PM -
Reducing Alcohol Induced Violence & Anti-social Behaviour
By echnidna in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 14Last Post: 13th August 2007, 05:30 PM