Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Drawbar brace method
-
9th February 2023, 01:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,434
Drawbar brace method
I need to brace a draw bar on a meduim sized box trailer , its looks like 75x50x2.1. The draw bar hasn't bent or anything but I want to strengthen it with 50x50x3 underneath regardless. Is the protocol stitch weld on one side every 200mm or stitch both sides ? I will brace the whole length on the draw bar which is approx 4m from end to end. Is 50x50x3 angle sufficient or rhs the better choice to brace it ? I've never braced a drawbar before so wasnt sure what the go is.
Read and reply to the full thread at metalworkorums.com....
-
9th February 2023 01:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Drawbar design help
By simonl in forum TRAILERS & OTHER FABRICATED STUFFReplies: 14Last Post: 31st March 2014, 12:02 AM -
sharpening knives on waterstones: japanese method vs western method
By J_SAMa in forum SHARPENINGReplies: 5Last Post: 28th December 2012, 04:35 AM -
Beefing up the drawbar - this OK?
By Wombat2 in forum TRAILERS & OTHER FABRICATED STUFFReplies: 4Last Post: 14th September 2012, 05:21 PM