Needs Pictures: 0
Results 106 to 113 of 113
Thread: I’m a convert!
-
1st April 2021, 03:40 PM #106
Constructive criticism is always welcome Ian .......... just don’t open any delivered parcels for a while though ?
Apparently the cordless microphone set up is very sensitive and “booms” if anything knocks the base on which it stands. They were also worried about the “clatter” of glasses of water being put down on the table-top so I went with leather partly for that reason. Veneer though would still have been better than the tempered glass of the old one!a rock is an obsolete tool ......... until you don’t have a hammer!
-
1st April 2021 03:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
1st April 2021, 03:55 PM #107
Sounds like they need you to retro fit adjustable feet for that beautiful fancy new lectern??
-
1st April 2021, 05:39 PM #108
-
1st April 2021, 07:36 PM #109
I'm relying on your age & sundry distractions to have erased all memory of my address after (however many years it's been) when you visited. But I will get my sniffer dog to check all incoming mail henceforth. That may not help much, the only odours she responds to are those related to food.....
OK, valid point about the over-sensitive mic. One should always be in possession of full facts before casting nastursulums.
Seems like they need a visit from a competent sound engineer.......
Cheers,IW
-
2nd April 2021, 11:44 AM #110
This is a seriously good thread - AND a seriously EXCELLENT outcome.
The lectern looks great. It fits the vibe, fits the existing style beautifully.
Not so sure about the Jesus in the background. Needs to be turned 30-45°.... and why does it have a portico???
-
2nd April 2021, 12:00 PM #111
-
2nd April 2021, 12:13 PM #112
-
2nd April 2021, 05:41 PM #113
Similar Threads
-
Convert MKII to RV...
By nickpullen in forum Michael Storer Wooden Boat PlansReplies: 0Last Post: 8th January 2016, 04:32 PM -
Kit to convert Hafco HM-45 to CNC
By Bob Willson in forum CNC MachinesReplies: 0Last Post: 31st May 2014, 12:03 AM -
Looking for a Mill to convert to CNC
By phomann in forum CNC MachinesReplies: 19Last Post: 1st July 2012, 12:04 PM -
Three phase to convert or not to convert?
By Kiwi Greg in forum HAND TOOLS - POWEREDReplies: 13Last Post: 23rd September 2007, 10:01 PM -
Another Convert
By olddog in forum FESTOOL FORUMReplies: 9Last Post: 9th September 2006, 11:07 PM