Article on a zigzag carver

[Rocker]

My original article on zigzag dining chairs - http://www.festoolusa.com/Web_files/...WCM_zigzag.pdf - did not include instructions for building a carver. Here is an article on building a matching carver; the chair is designed so that its mortices can either be routed with a morticing jig, or else milled with a Domino tenon-joiner. The zigzag dining chairs described in the original article were designed to be built using a Domino. But the design could easily be modified to be made with a router and morticing jig by substituting a single through tenon to reinforce the mitre joints, as in the carver.

This article is one of three describing the building of a zigzag dining set. The zigzag dining table article is posted in post #18 in this thread: http://www.woodworkforums.ubeaut.com...t=50036&page=2 . I posted that article without most of its photos, but most of them were posted in the thread.

Rocker

Rocker

[Pops]

Hi Rocker,

Thanks for that. Just love that chair. (followed your previous threads of course).

It is on the 'to do' list.

Well done on the article publication.

Cheers
Pops