Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
21st June 2021, 04:41 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Carbide tool for my 9 inch lathe. A question or two.
Good morning everyone. So as per my other thread, you can see that i've been havign issues with finish ect:
I wanted to grab a carbide holder and insert tool setup to give it a try and see if it's the tool rather than anything else giving me problems.
My question is. What size bit holder do i need so that i don't need to prop it up with spacers ect: ( no height adjustments )
South bend 9 inch lathe. There are no model markings or brandings that i can see anywhere on the unit. There is something stamped into the way on the right side, but it's scratched up a bit and i cannot work it out.
Also open to suggestions and what to get as well as long as it doesn't absolutely kill the wallet :O
182956545_550060879310973_1668729794378849342_n.jpg
196370815_236027307990123_3367525255444109091_n.jpg
Attached Images
- 182956545_550060879310973_1668729794378849342_n.jpg (139.8 KB)
- 196370815_236027307990123_3367525255444109091_n.jpg (103.4 KB)
Read the full thread at metalworkforums.com...
-
21st June 2021 04:41 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Lathe carbide tool geometry
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 18th April 2021, 05:30 PM -
Hafco AL50G 9 x 19 lathe carbide tool advice wanted
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 5th March 2019, 03:20 PM -
Carbide tipped tool
By Simomatra in forum WOODTURNING - PEN TURNINGReplies: 3Last Post: 12th April 2010, 01:03 PM -
carbide tool
By tanii51 in forum METALWORK FORUMReplies: 1Last Post: 20th November 2009, 08:18 AM -
Novice lathe tool bit question
By over40pirate in forum METALWORK FORUMReplies: 6Last Post: 8th September 2009, 10:04 PM