Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Chuck Indexer
-
9th June 2020, 06:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Chuck Indexer
I drilled 12 holes in the backplate of my 3 jaw chuck using my indexing attachment and cross-slide mounted drill. I made a pin from 10mm W1 with a slightly tapered tip. The brass knob has a M12 thread which forces the pin into the 4mm holes in the chuck. I remove the pin when I want to fit the 4 jaw chuck. I need to remove the whole assembly (two cap screws) on the rare occasion I use the face plate.
My original indexer will still be needed for the 4 jaw chuck, collet chuck and face plate. The advantage of this indexer is that it requires no setup when you just want to make 2, 3, 4 or 6 holes/slots in a workpiece.
Attached Images
Read the full thread at metalworkforums.com...
-
9th June 2020 06:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
5C Spin Indexer Modifications
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 20th November 2019, 01:50 PM -
What is this ? Lathe bed indexer or something else ?
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 6th December 2017, 12:11 PM -
Hercus Indexer - Photos for Joe.
By Anorak Bob in forum METALWORK FORUMReplies: 13Last Post: 4th March 2012, 12:18 PM