Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Fitting a single phase motor
-
6th February 2022, 10:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,443
Fitting a single phase motor
Hi guys, this is my first post on the forum. I am putting one of the techtop single phase motors onto my 260, but have discovered that the drive frame casting prevents it from fitting into place. I've seen some mentions on other threads about modifying the casting to take a larger motor but am nervous to go for it without getting some advice first. Can anyone please tell me whether cutting into the casting to create space for the motor is a good or bad idea? The photo is to show what I would be cutting away, in case I haven't done a very good job of explaining. Any help will be appreciated. Thanks
Attached Images
- IMG20220206191206.jpg (200.4 KB)
Read the full thread at metalworkforums.com...
-
6th February 2022 10:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
fitting single phase motor to old 3 phase lathe
By Sebastiaan76 in forum WOODWORK - GENERALReplies: 15Last Post: 11th February 2016, 11:39 PM -
Replacing A Single Phase Motor With A Three Phase Motor....................
By matthew_g in forum METALWORK FORUMReplies: 26Last Post: 1st May 2015, 04:42 PM -
rewire 3 phase motor to single phase
By thorens in forum METALWORK FORUMReplies: 36Last Post: 5th September 2014, 07:16 PM -
Looking to swap a 2Hp single phase motor for 1.5 or 2Hp 3-phase motor
By jhovel in forum METALWORK FORUMReplies: 7Last Post: 10th March 2014, 07:26 PM