Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Headstock Removal on model c
-
28th August 2020, 07:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,436
Headstock Removal on model c
I went to remove the headstock on my model c with cast iron bearings today.
I did a lot of reading about the method and was prepared with a hammer and hardwood.
I did everything suggested but when I went to knock the headstock out, it came out with a bump of the hand?
I checked all surfaces and they all look good.
It does leak oil from the front bearing though.
Did I just get lucky with the removal or would it be because of wear?
It snugs back up nicely and seemed to run nice and true whilst not getting hot.
Cheers
Andrew.
Read the full thread at metalworkforums.com...
-
28th August 2020 07:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Model A Apron on Model C Hercus Lathe?
By MWF FEED in forum THE HERCUS AREAReplies: 0Last Post: 11th December 2018, 09:30 PM -
Model T Ford & garage for Model T Plans
By Matador in forum TOY MAKINGReplies: 0Last Post: 4th June 2014, 10:46 PM -
Noise from headstock
By rsser in forum WOODTURNING - GENERALReplies: 17Last Post: 9th November 2012, 02:25 PM -
Sheraton Model AM Spindle removal?
By Com_VC in forum THE HERCUS AREAReplies: 19Last Post: 14th April 2011, 06:02 PM