Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Need help identifying a part
-
17th July 2022, 02:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,424
Need help identifying a part
Hello again,
I have often wondered what this part is called and what it is used for. I cannot think of a practical purpose but it would not have been made so specifically if it did not perform some useful function.
It sits in a hole in the top of the tailstock. This hole is not a through hole so it is not an oiling hole and it is also not deep enough to be a repository for very much of anything.
Dimensions are 30mm LOA and the bulbous part is ~10mm diameter.
Can anyone please help?
Thank you
part.jpg
Attached Images
- part.jpg (106.8 KB)
Read the full thread at metalworkforums.com...
-
17th July 2022 02:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
tracing out a full sized coastal rowing boat pdf file part 1 and part 2
By woodman12 in forum CNC MachinesReplies: 0Last Post: 21st February 2021, 06:36 AM -
Differences in Single Part & Two Part Polyurethane Glues
By Chris Parks in forum WOODWORK - GENERALReplies: 2Last Post: 18th September 2019, 09:09 AM -
Help identifying part of BP-355 bandsaw
By Arron in forum BANDSAWSReplies: 4Last Post: 15th February 2015, 07:19 AM -
building a vac press for veneering part 1 part 2
By woodman12 in forum CNC MachinesReplies: 6Last Post: 13th January 2014, 11:24 AM -
Help identifying part for a broken bandsaw
By Shannon in forum BANDSAWSReplies: 5Last Post: 3rd February 2013, 09:47 AM