Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Hercus 260 belt replacement.
-
2nd June 2021, 11:20 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,401
Hercus 260 belt replacement.
I just replaced the link-belt back to V-belt recent as the link belt seems to be too stiff (it came with the lathe when I bought it). I decided to go the the automotive notched belt rather than the banded V-belt. I am not too sure how long it will last if there is oil present but that seems much more smoother to run especially on the small pulley selection. The tension lever is much lighter as well.
I bought the A28 banded too just in case. I think I would replace with the 13A-750 again if is lasts more than 5 years.
20210602_074140.jpg
20210602_074314.jpg
Attached Images
- 20210602_074314.jpg (186.1 KB)
- 20210602_074140.jpg (167.0 KB)
Read the full thread at metalworkforums.com...
-
2nd June 2021 11:20 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Jointer V belt replacement
By plunger in forum WOODWORK - GENERALReplies: 0Last Post: 14th February 2019, 02:16 AM -
Where to get replacement belt for MC900
By Paulphot in forum WOODTURNING - GENERALReplies: 7Last Post: 18th March 2011, 08:16 PM -
GMC Saw Bench - Replacement Belt
By tolyinoz in forum TABLE SAWS & COMBINATIONSReplies: 4Last Post: 1st October 2010, 10:50 PM -
Replacement belt - where can I get one
By Mindabout in forum HAND TOOLS - POWEREDReplies: 14Last Post: 12th August 2006, 12:22 AM