Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Hercus 9" A model headstock belt
-
23rd October 2020, 05:40 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,435
Hercus 9" A model headstock belt
Gday,
Wondering if anyone can confirm which length of belt I need for the headstock pulley on my horizontal drive model A?
I noticed that the motor kind of bobs up and down as the machine runs and for a while couldn't work out how this was possible and then it occurred to me that the headstock belt must be stretched or whatever, because it would appear to be the culprit and it brings the floating rear pulley/motor assembly in and out as it runs.
I can see AMH website does list a few belts but none that are specifically for the horizontal belt setup, or at least that I could see.
Cheers,
ratters
Read the full thread at metalworkforums.com...
-
23rd October 2020 05:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Hercus 9" AR Belt change
By MikeMaidavale in forum THE HERCUS AREAReplies: 11Last Post: 13th March 2015, 06:38 AM -
hercus 9" c model
By tryhard202 in forum THE HERCUS AREAReplies: 1Last Post: 4th November 2012, 11:43 PM -
Flat belt 9" Hercus Lathe
By omshree in forum THE HERCUS AREAReplies: 4Last Post: 17th May 2012, 11:56 PM -
Wanted early hercus 9" headstock
By bitza500 in forum THE HERCUS AREAReplies: 0Last Post: 25th December 2008, 12:31 AM