Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: hercus cross slide binding
-
25th May 2020, 01:40 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
hercus cross slide binding
I've had some trouble adjusting the cross slide on my hercus. If I adjust it so there's minimal play in the normal operating range I can't slide it right off the back because it binds at the back. I think the machine has seen a decent amount of use so not unexpected. I assume either the saddle or slide dovetails are out of parallel. To correct this problem, would I have to grind or scrape the dovetail surfaces? Has anyone tried to fix this issue? I'd actually like to learn how to scrape but I would have to invest quite a bit to get the required tools.
Read the full thread at metalworkforums.com...
-
25th May 2020 01:40 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
hercus c extended cross slide
By MWF FEED in forum THE HERCUS AREAReplies: 0Last Post: 15th February 2020, 09:40 AM -
Hercus 9C cross slide milling rig.
By MWF FEED in forum THE HERCUS AREAReplies: 0Last Post: 26th March 2019, 01:40 PM -
Hercus 9C cross slide milling rig.
By MWF FEED in forum THE HERCUS AREAReplies: 0Last Post: 26th March 2019, 01:30 PM -
Cross Slide Scraping Hercus 260
By Abratool in forum THE HERCUS AREAReplies: 3Last Post: 14th November 2014, 05:06 PM -
Hercus 260 Cross-slide play
By jack620 in forum THE HERCUS AREAReplies: 19Last Post: 26th September 2011, 08:47 PM