Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Hercus Mill X, Y Z feed screws
-
16th January 2020, 06:10 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,434
Hercus Mill X, Y Z feed screws
Got a question about the Hercus Mill . I believe my small mill was pre metric manufactured so was fitted with dials, graduated in .001". When the country changed over to the metric system the dials were replaced with metric ones. What I dont know is if the feed screws for X,Y & Z axis were changed also.
This query has been brought about by the fact that my mill like other Hercus mill is vertically challenged on the Z axis. After putting up with minimal work space for years, I have decided to add a 150mm block to the column which will mean an extended Z screw is required.
Now I have measured the Z Screw and it appears to be square thread , pending inspection with a magnifying glass, it is 0.751" OD and 4mm pitch. An odd combination I know but thats the best fit dimensions I can up with.
Can any Hercus guru shed any light on the fact that the lifting screw is an original or an upgrade replacement due to metricification. Also have a lot of backlash in the Y feed screw nut that needs to e looked at. The Z screw is not really a problem, being a fitter I'll just make an extension to suit the existing nut, whatever the thread may be, but my curiosity is aroused as the Z screw is not even close to any standard thread I can find, perhaps A Hercus special. Love to hear your thoughts guys
Read the full thread at metalworkforums.com...
-
16th January 2020 06:10 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Hercus Mill - Oiling Longitudinal Feed Handle and Huge Movement
By MWF FEED in forum THE HERCUS AREAReplies: 0Last Post: 14th April 2019, 09:00 PM -
Cross feed fix for SB or Hercus ?
By morrisman in forum METALWORK FORUMReplies: 0Last Post: 28th September 2012, 08:27 PM -
slowest feed setting on hercus 260
By bt 66 in forum THE HERCUS AREAReplies: 5Last Post: 4th July 2011, 02:30 PM -
Arboga EM825 mill vs Hercus model 0 mill?
By neksmerj in forum METALWORK FORUMReplies: 23Last Post: 14th May 2011, 03:16 PM -
Hercus 9" Model A Feed Nuts
By wannabe in forum THE HERCUS AREAReplies: 2Last Post: 18th November 2010, 11:26 AM