Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
Thread: tailstock centre
-
28th October 2009, 06:13 PM #1SENIOR MEMBER
- Join Date
- Nov 2005
- Location
- adelaide
- Posts
- 667
tailstock centre
will this set up help get my tailstock lined up as pic shows the dial indicator held in the chuck running around a centrepoint maybe it would be better using a arbor from a drill chuck
-
28th October 2009 06:13 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
29th October 2009, 05:26 PM #2GOLD MEMBER
- Join Date
- Jun 2007
- Location
- sydney
- Age
- 64
- Posts
- 3,566
Are you trying to align the Tailstock on centre to the lathe spindle.
-
29th October 2009, 07:11 PM #3SENIOR MEMBER
- Join Date
- Nov 2005
- Location
- adelaide
- Posts
- 667
yes pipeclay that was the aim and after i read the book again heres the results ......
with the dial indicator i adjusted the tailstock side ways to give as close a reading horizontally as i could ( .003variation from side to side)). then i found an old dumbell handle and chucked it up and made a centre hole on the opposite end for the live end. turned the 2 collars till thyey were running straight then a very fine pass once more voila the old moore n wright
said the 2 collars were with in .002 was it a fluke
-
29th October 2009, 08:15 PM #4GOLD MEMBER
- Join Date
- Jun 2007
- Location
- sydney
- Age
- 64
- Posts
- 3,566
Maybe not but do your test between centres and see if you get a similar result.
-
29th October 2009, 08:19 PM #5
whack a bit of stock into the chuck and turn a small inverted vee in the centre of the stock , run your tail stock up and set the point of the center to the vee , making your adjustments till the centre is spot on to the turned vee , works for me, quick and easy without the problem of setting up a dial gauge espically where clearance is a problem
Ashore
The trouble with life is there's no background music.
-
29th October 2009, 08:47 PM #6SENIOR MEMBER
- Join Date
- Nov 2005
- Location
- adelaide
- Posts
- 667
turn between centres now i need a dog hmmm the retainers off the the weight bar i chopped up might do this is fun
Similar Threads
-
Tailstock reassembly
By Tiger in forum WOODTURNING - GENERALReplies: 3Last Post: 23rd August 2009, 10:13 PM -
Tailstock Quill
By CameronPotter in forum WOODTURNING - GENERALReplies: 11Last Post: 27th February 2009, 02:45 PM -
Tailstock adaptor
By TTIT in forum WOODTURNING - GENERALReplies: 4Last Post: 22nd September 2007, 03:19 PM -
Now for the tailstock
By Tiger in forum WOODTURNING - GENERALReplies: 8Last Post: 7th June 2006, 09:50 AM -
Replacing tip in tailstock centre
By Tiger in forum WOODTURNING - GENERALReplies: 10Last Post: 25th May 2006, 10:24 PM