Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
22nd June 2015, 08:31 PM #1.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 5,650
TECO Single Phase Motor for Hercus No.O
Ken had asked me for some photos of the motor I once had powering my mill. I paid a bit over 200 dollars for the TECO. I subsequently located a star/delta wound ASEA motor of the same size and appearance as the original ASEA fitted by Hercus which I ran via a TECO FM50 VFD. The motor is about 300mm in length, roughly 85 mm longer than the original.
I'm posting the photos here because there's a good chance Ken would lose them if I sent them to him.
BT
-
22nd June 2015 08:31 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
22nd June 2015, 09:13 PM #2Product designer retired
- Join Date
- Nov 2006
- Location
- Heidelberg, Victoria
- Age
- 80
- Posts
- 2,251
0 mill motor replacement
Thank you Bob, beautiful pictures that we've come to expect.
Has using the VFD made using the mill a nicer experience?
Me....? lose photos, never!
In any case, I can always rely on you to dig them out of your archives.
Ken
-
22nd June 2015, 10:25 PM #3Mechanical Butcher
- Join Date
- Oct 2004
- Location
- Southern Highlands NSW
- Posts
- 920
-
22nd June 2015, 10:58 PM #4.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 5,650
-
23rd June 2015, 07:44 AM #5SENIOR MEMBER
- Join Date
- Oct 2011
- Location
- sydney
- Posts
- 880
Hi Ken,I have a cheap VFD on my mill, works fine. Just as AB said, easy start up and stopping plus variable speed and reverse. The original motor that came on my mill was able to be converted to run a VFD. Only cost $50 or $60 (I think).On my 260 I converted it to single phase, which I regret due to the above reasons and how harsh the start up is.Ben
Similar Threads
-
Replacing A Single Phase Motor With A Three Phase Motor....................
By matthew_g in forum METALWORK FORUMReplies: 26Last Post: 1st May 2015, 04:42 PM -
Looking to swap a 2Hp single phase motor for 1.5 or 2Hp 3-phase motor
By jhovel in forum METALWORK FORUMReplies: 7Last Post: 10th March 2014, 07:26 PM -
Hercus 3 phase lathe, single phase supply
By Pete F in forum THE HERCUS AREAReplies: 51Last Post: 16th January 2009, 10:15 AM -
replacing three phase motor with single phase
By rev in forum HAND TOOLS - POWEREDReplies: 18Last Post: 16th December 2007, 04:32 PM