Thread: RYOBI SC-160 12 years old need some info

Don't know if this will help - it's from an sc-1600vl. Might give you an idea though.

Originally Posted by nysevor

i just purchsed and from RYOBI i have received contact that it's 12 years old . does anyone know where i can obtain through PDF files a manual for set up and replacing chuck's for pinless blades ? i found a parts diagram so that's not needed . this is a backup for my craftsman and hawk saw's . any help would greatly appreciated

G'Day nysevor,
I have the original manual for that saw (SC-160 Scroll Saw 16"), that came with it in the box, is this what you are after?...If so, I can't send it in PDF format, but I can scan it into MS WORD, is this OK?..
savage(Eric).

Savage - yes most definetly that works . it would so usefull . i can't say thanks anough .....

Chuck

Originally Posted by HoutBok

Don't know if this will help - it's from an sc-1600vl. Might give you an idea though.

Thanks - it what is needed to install what i have too . thanks again

G'Day nysevor,

another attempt to send you the manual, hope it works, if not e-mail me and I'll send it the regular e-mail.
savage(Eric)

Eric , i didn't get anything ! did you send it to [email protected] ? thanks so much - Chuck

I have recieved everything that's needed for this scroll saw . without everyone's help , especialy savage it couldn't be done !!!! happy scrolling and stay healthy . will be around so write if you like ..
i know it's summer in Australia . Unfortuantly winter's knocking on our back door . this season they're claiming a bad winter . can't stop it so will scroll and smile at the snow drifts .
Chuck

All,
I am in the same situation, I just purchased a used Ryobi model SC-160 that is in need of some upkeep. It was sitting in a garage near the coast for 9 years and has a lot of surface rust. I would like to take it apart and clean it up but don't have a manual to ensure I get everything right. Anyone still have a way to send a copy of the manual electronically. My email address is [email protected]. Thanks.
Papamaynard

Just send the pdf file to your email, or you can also check the link here
http://www.toolpartsdirect.com/cgi-b...gi/ryobi/SC160

Hello to All,

I'm new to this forum, and am searching for a couple of owner's manuals for two items. Both are Ryobi, and the first one is a Model SC-160 16" Scroll Saw, and the other is a 10" Compound Miter Saw. One of my Sons gave them to me, (he got them from his neighbor), but nobody had the manuals, so I'm trying to find them. Any help at all would be greatly appreciated, and PDF files are great, manuals are great, anything close to the originals.

Thanks again,

Jim

Hello, Jim again here,

If anyone has any insight into these two manuals, please email me at
[email protected]

Thanks again,

Jim

Originally Posted by jimbailey

Hello, Jim again here,

If anyone has any insight into these two manuals, please email me at
[email protected]

Thanks again,

Jim

Jim, have sent you an e-mail, if you didn't get it, you can P.M. me.

P.S. Thanks Buzza

I can't believe you people are putting up all those Email addresses for the whole wide world to see.

If I were you, I would take them down real soon to avoid all the pests and spammers. The other way is available to you all, why not be safe and use it?

I'm only thinking of you, my fellow Formites on here Guys.

I hope I am not too late...ha. Anyone feel kind enought to share their instruction manual for the SC-160? I can find the parts diagram, but cannot locate a manual anywhere.

Thanks for the help!