how to reglue finger jointed board

[seliduka]

I have a walnut finger jointed board, it's about 90"L×20"W×1/2"H, glue with Titebond 3, the problem is there have a lot of piece are bore by pests.

Now, i cut some new piece to replace them, but i can't separates those tiny piece.
how can i do?

[elanjacobs]

I don't think it's possible without cutting the panel up and making it again

[seliduka]

What a bad news

thanks, ej

[Beardy]

You won’t be able to separate the fingers but you could ruin it through the saw adjacent to the joint and then cut a new finger into it

[Crunchie]

You won’t be able to separate the fingers but you could ruin it through the saw adjacent to the joint and then cut a new finger into it

"...

but you could ruin it …"

Was that a Freudian slip, a case of fingers hitting the keyboard, or a good use of dry humour?

[Beardy]

"...

but you could ruin it …"

Was that a Freudian slip, a case of fingers hitting the keyboard, or a good use of dry humour?

Hahaha just picked up on my typo make that “run” and try not to ruin it in the process