Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
-
30th August 2020, 02:49 PM #1Novice
- Join Date
- Jul 2020
- Location
- Toyko
- Posts
- 14
What trim router bit cuts this type of edge
It's a classic pine table edge but what bit is used (see attachment)
-
30th August 2020 02:49 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
30th August 2020, 02:55 PM #2
Hi,
A round over bit with a smaller guide bearing fitted.
RegardsHugh
Enough is enough, more than enough is too much.
-
30th August 2020, 02:56 PM #3
Just looks like a basic roundover bit was used.
04A4E609-2560-4A6C-BC53-52F463E5F177.jpeg
I wouldn’t use a trim router though unless that’s all you have available. You’ll have to take many light cuts dropping the bit down a smidge each time. Definitely make a long sub-base out of perspex or similar to stabilise the machine.
8A431E3E-824F-43E5-9B2F-53F940B59B29.jpegNothing succeeds like a budgie without a beak.
-
30th August 2020, 03:12 PM #4Taking a break
- Join Date
- Aug 2008
- Location
- Melbourne
- Age
- 34
- Posts
- 6,127
-
30th August 2020, 03:39 PM #5China
- Join Date
- Dec 2005
- Location
- South Australia
- Posts
- 4,478
AS said above, note, most trim routers would be working hard on top that size.
-
31st August 2020, 08:50 AM #6Novice
- Join Date
- Jul 2020
- Location
- Toyko
- Posts
- 14
Thanks for the bit type and offset sub-base advice; I'll make one up and practice a lot before attempting this.
Similar Threads
-
Does anyone have any tips for using a trim router to trim melamine edging?
By Tccp123 in forum WOODWORK - GENERALReplies: 12Last Post: 18th December 2018, 07:10 AM -
Applying flexible edge trim rubber moulding
By jk200sx in forum FURNITURE, JOINERY, CABINETMAKING - formerly BIG STUFFReplies: 12Last Post: 13th January 2018, 05:07 PM